The maximum rated weight of the Whitebox is 2.5lbs (1.1kg). When 2.5lbs is on the Whitebox, it will only last around 2 minutes before the fuse blows. See “Runtime vs Payload” under the “Whitebox Operation” section to better understand loading the Whitebox.
How long can I run my Whitebox?
The maximum runtime of the Whitebox is 5 minutes due to the timer that comes programmed on the device. This runtime can decrease drastically depending on the payload on the Whitebox.
How can I make the lid easier to remove?
The simplest solution we have found is using a loop of tape that is attached to the inside of the lid.
Is the Whitebox supposed to spin on its own?
Yes. Since the Whitebox is an experimental device, it is not optimized for perfect stability. Since the Whitebox hovers, any mass imbalance or speed differential of the individual Hover Engines can cause the Whitebox to spin. If your Whitebox is spinning really quickly (i.e. 360 degrees in less than 1 second) then one of your Hover Engines is probably wired …
Where do I put the battery?
The battery that comes with the Whitebox should have a piece of Velcro that matches the Velcro on the inside of the lid. After securing the battery to the lid, you need it connect it to the ESC in the Whitebox. Make sure that it is not making contact with any of the internal components or having its wires pinched …
Why is there a fuse?
The fuse is there to protect the battery. The Whitebox comes with a LiPo battery which can catch fire if it overheats or over-discharges.
Why does the hover surface get hot?
The Hover Engines create a primary magnetic field, which induce eddy currents in the hover surface. By Lenz’s Law, these eddy currents create a secondary magnetic field that repels the first and creates lift. The eddy currents can also create a lot of heat, especially when the Whitebox is hovering in the same position for a long time. For this …
My Whitebox got stuck to something. What’s the best way to remove it?
Increasing the distance between the Hover Engines and the thing its stuck to will drastically decrease the force required to remove the Whitebox. Tools such as shims are useful for aiding separation. When trying to remove the Whitebox, sliding instead of pulling should also help dramatically. Once the Whitebox is removed, check the bottom for damage. If you see cracked …
Why does the lid keep popping off?
Although the top seems like it can be put on any direction, the magnets are paired such that only one orientation is correct. Use the match arrows on the inside of the lid and the inside of the Whitebox to ensure proper alignment.
Why is there a hole in the front?
The slot in the front of the Whitebox allows access to the Teensy LC Microcontroller. This is only meant for those that are following the Whitebox Developer’s Guide.
- Page 1 of 2
- 1
- 2